Individual Wire, Installing

WARNING: This page is about a different variant/trim than selected.

WARNING:

Follow all safety precautions when working on pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
Before handling pyrotechnic components (for example, connecting a connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
Follow all the instructions when installing the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .

Install In Reverse Order Of Removal And Note The Following:

-- When bundling and placing individual wires, make sure the wires are not twisted.

NOTE:

When installing, position all cable ties, cable holders and clips in same place.

Make sure the connectors are installed all the way and engage audibly.