Driver/Front Passenger Seat Angle Adjustment Motor -V243- / -V244-, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Move the front seat into its highest position.
-- Unscrew the front seat and tip to the rear with the wires attached. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Remove the bolt -2- for the seat angle adjustment motor adjustment spindle -1-.
CAUTION:
Risk of damage to the bushing -1- in the bearing point -2- (adjusting spindle/seat pan bolting).
- The bushing cannot be replaced with workshop materials.
- If the bushing is damaged, the corresponding assembly parts must be replaced.
-- Disconnect the connector -3- at the seat angle adjustment motor.
-- Remove the bolts -1- and the seat angle adjustment motor -4-.