Overview - Seat Pan, Power Seat Pan Frame
WARNING: This page is about a different variant/trim than selected.
- Bolt
- 22 Nm
- Self-locking
- Replace after removing.
- Clean the threaded hole for the bolt with a thread tap, for example
- Bolt
- 22 Nm
- Self-locking
- Replace after removing.
- Clean the threaded hole for the bolt with a thread tap, for example
- Seat Pan Upper Frame
- Removing and Installing. Refer to SEAT PAN UPPER FRAME, REMOVING AND INSTALLING, POWER FRONT SEAT .
- To replace, install all electrical and electronic components and wires in the new upper frame.
- Bolt
- 22 Nm
- Self-locking
- Replace after removing.
- Clean the threaded hole for the bolt with a thread tap, for example
- Seat Pan Lower Frame
- Driver side: with Driver Seat Forward/Back Adjustment Motor -V28-
- Front passenger side: with Front Passenger Seat Forward/Back Adjustment Motor -V31-
- Cannot be disassembled; motor and seat pan lower frame are pre-adjusted from the manufacturer
- Removing and Installing. Refer to SEAT PAN, REMOVING AND INSTALLING, POWER FRONT SEAT .
- To replace the seat belt latch install in the new lower frame
- Bolt
- 22 Nm
- Self-locking
- Replace after removing.
- Clean the threaded hole for the bolt with a thread tap, for example
- Bushing
- Inserted in all bearing locations
- Cannot be replaced with service equipment
- The assembly component must be replaced if the bushing is damaged