Calibrating Procedure
WARNING: This page is about a different variant/trim than selected.
The Vehicle Diagnostic Tester is connected.
-- Select the Diagnostic mode and start the diagnosis.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Body
- Electrical system
- 01 - OBD-capable systems
- 6C - Rearview camera system control module - J772
- 6C - Rearview camera system control module, functions
- 6C - Calibrating
From here, the Vehicle Diagnostic Tester advances the calibration procedure forward.
WARNING:
Make sure light does not reflect off the calibration board.
Reflections impair the Rearview Camera -R189- and may make it impossible to perform the calibration.