Calibration Requirements

• The camera lens must be clean.
• The vehicle must be standing on a firm and level surface.
• There must be enough clearance around the vehicle (at least 2 meters).
• The parking brake must be set.
• The steering wheel must be in the 0 position and the wheels must be straight.
• All doors and the rear lid must be closed.
• No one should be in the vehicle.
• The vehicle must not be loaded (curb weight).
• Connect the battery charger.
• Ignition switched on.

The :VAS6350A  consists of the following parts:

• Calibration Tool - Wheel Center Mountings:VAS6350/1 
• Calibration Tool - Spacing Laser:VAS6350/2 
• Calibration Tool - Linear Laser:VAS6350/3