LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A3 Premium, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 43 (COMMUNICATION (2 Of 2) -- (A3 SEDAN)) >> 91 Communication >> Radio >> Overview - Radio >> Overview - Radio, MMI Radio Plus (I8S), From My 2017

Overview - Radio, MMI Radio Plus (I8S), From My 2017

WARNING: This page is about a different variant/trim than selected.

I8S - MMI Radio Plus 

Optional 

GWWA91-11982Courtesy of AUDI OF AMERICA, LLC
  1. Roof Antenna -R216-
    • Not for the convertible
  2. Front Information Display Control Head -J685- in Center of the Instrument Panel
  3. Rear Window Antennas (3-door and 5-door, sedan)/Front and Rear Window Antennas Plus Antennas in the Side Trim Panels (Convertible)
  4. Information Electronics Control Module 1 -J794- in the Glove Compartment
  5. Multimedia System Control Head -E380- in the Center Console
  6. Sound Systems
  7. MOST Bus
  8. Digital Sound System Control Module -J525- under the Left Front Seat
  9. Microphone Unit in Front Roof Module -R164- (Telephone Microphone -R38-) in the Front Interior Lamp -W1-
  10. External Audio Source Connection -R199- in the Center Console Storage Compartment

The data exchange for the Bang & Olufsen sound system (9VS) and the TV Tuner -R78- (QV1) occurs through the MOST bus.

The connection to other vehicle systems is established through the CAN bus (Infotainment) and the Data Bus on Board Diagnostic Interface -J533-.

Fault Finding is performed using the "Guided Fault Finding" on the Vehicle Diagnostic Tester .

Notes on MOST bus

The optical data bus "MOST bus" is used in addition to the CAN bus.

A fiber-optic cable is used as a "connecting cable". Fiber optic cables are routed inside corrugated tubes for protection.

Replace the complete fiber-optic cable if possible.

The front surface of the connectors must not be contaminated.

If disconnecting the connectors: Attach the :VAS6223/9  .

Fig 1: Fiber-Optic Conductor Repair Set VAS 6223A
GWWW00-11495Courtesy of AUDI OF AMERICA, LLC

When routing fiber-optic cables, make sure not to go below the minimum bending radius of 25 mm. Do not crush or kink fiber optic cables.

Repairing fiber-optic cables. Refer to FIBER-OPTIC CABLES, REPAIRING .