Bumper Antennas, Removing And Installing, Sedan And Convertible: Removing
WARNING: This page is about a different variant/trim than selected.
-- Turn off the ignition and all electrical equipment and remove the ignition key.
-- Remove the rear bumper cover. Refer to REAR BUMPER COVER, REMOVING AND INSTALLING .
-- Release and disconnect the connector -2- for the left bumper antenna -1-
NOTE:
Depending on the version of the installed bumper antenna, the connector -2- may be located directly on the bumper antenna -1-.
-- Remove the nut -5- for the left bumper antenna -1-.
-- Remove the left bumper antenna -1- from the bracket -4-.
-- Remove the nuts -3- for the bracket -4-
-- Remove the bracket -4- from the vehicle body.