Antenna Amplifier 3 -R112-, Removing And Installing, Sedan: Removing
WARNING: This page is about a different variant/trim than selected.
-- Turn off the ignition and all electrical equipment and remove the ignition key.
-- Remove the right D-pillar trim panel. Refer to D-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
-- Remove the rear shelf. Refer to REAR SHELF, REMOVING AND INSTALLING .
-- Release and disconnect the connectors -2 and 3- from the Antenna Amplifier 3 -R112- -1-.
-- Only loosen the screw -4- (do not remove) and remove the Antenna Amplifier 3 -R112- -1- from the D-pillar.