Antenna Amplifier 3 -R112-, Removing And Installing, 3-Door And 5-Door Vehicles: Removing
WARNING: This page is about a different variant/trim than selected.
-- Turn off the ignition and all electrical equipment and remove the ignition key.
-- Remove the upper rear lid trim panel. Refer to REAR LID UPPER TRIM PANEL, REMOVING AND INSTALLING .
-- Release and disconnect the connectors -2 and 4- from the Antenna Amplifier 3 -R112- -1-.
-- Only loosen the screw -3- (do not remove) and remove the Antenna Amplifier 3 -R112- -1- from the rear lid.