Antenna Amplifier 2 -R111-, Removing And Installing, Convertible: Removing
WARNING: This page is about a different variant/trim than selected.
-- Bring The Convertible Top And Convertible Top Compartment Cover Into The Service Position as shown. Refer to the appropriate service information. .
-- Push the convertible top compartment cover upward until it engages.
-- Turn off the ignition and all electrical equipment and remove the ignition key.
-- Support the convertible top with a suitable wood rod.
-- Release and disconnect the connectors -2 and 4- from the Antenna Amplifier 2 -R111- -1-.
-- Remove the screw -3- and remove the Antenna Amplifier 2 -R111- -1- from the main bearing for the convertible top on the right side.