Headliner, Removing And Installing, Sedan: Removing
Follow all safety precautions when working on pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
Versions Equipped With A Sliding Sunroof:
-- Open the sliding sunroof -1- all the way.
-- Open the sun shade -2- about 2 /3 .
-- To avoid dirtying the headliner, clean the :T40233 .
-- Push the :T40233 between the cover frame -2- for the sunroof opening and the headliner.
-- Release the cover frames using the :T40233 one after each other from the brackets -1- -arrows-, as shown in the illustration.
Continuation For All Vehicles:
-- Remove The Front Passenger Door. Refer to DOOR, REMOVING AND INSTALLING .
-- Remove the front passenger seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Remove the A-pillar upper trim panels. Refer to A-PILLAR UPPER TRIM PANEL, REMOVING AND INSTALLING, A3 E-TRON/SEDAN .
-- Remove the upper B-pillar trim panels. Refer to UPPER B-PILLAR TRIM, REMOVING AND INSTALLING, A3 SPORTBACK/SEDAN .
-- Remove the D-pillar trim panels. Refer to D-PILLAR TRIM PANEL, REMOVING AND INSTALLING, SEDAN .
-- Remove the C-pillar trim panels. Refer to C-PILLAR-TRIM PANEL, REMOVING AND INSTALLING, SEDAN .
-- Remove the center console. Refer to CENTER CONSOLE, REMOVING AND INSTALLING .
-- Remove The Front Roof Module. Refer to FRONT INTERIOR LAMP -W1-, REPLACING (FRONT ROOF MODULE) / OVERVIEW - ROOF TRIM PANEL CONTROLS (For the Front Interior Lamp -W1- with an LED bulb, the entire front roof module must be replaced if one of the LEDs is faulty.) .
-- Vehicle versions with a front camera: remove the front camera trim. Refer to REMOVING - INTERIOR REARVIEW MIRROR WITH OPTIONAL EQUIPMENT: .
-- Remove The Vanity Mirror Light. Refer to DRIVER/FRONT PASSENGER VANITY MIRROR LAMP -W20- / -W14-, REMOVING AND INSTALLING /OVERVIEW - ROOF TRIM PANEL CONTROLS .
-- Remove the sun visors. Refer to SUN VISOR, REMOVING AND INSTALLING .
-- Remove the sun visor center support. Refer to SUN VISOR CENTER SUPPORT, REMOVING AND INSTALLING .
-- Remove the roof grab handle. Refer to ROOF GRAB HANDLE, REMOVING AND INSTALLING .
-- Move the steering wheel as far upward as possible using the entire adjustment range of the steering column.
-- Move the driver seat into the deepest and most forward position and position the backrest as far toward the rear as it will go.
- The headliner bends easily.
- Replace the headliner if it is bent.
-- Unclip the rear headliner at the clips -1 and 3- from the body -arrows- using the :80 - 200 .
-- Unclip the rear headliner at the centering pin -2- from the body.
The headliner is removed through the front passenger door.
-- Open the left rear door.
-- Lower the front headliner -1- and turn to the passenger door opening, to do this tip the left side downward.
-- Remove the headliner through the front passenger door opening as shown.