Rear Armrest, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Remove the door trim panel. Refer to REAR DOOR TRIM PANEL, REMOVING AND INSTALLING .
-- Remove the insulation mat.
-- Remove The Window Regulator Switch Refer to OVERVIEW - REAR DOOR CONTROLS / WINDOW REGULATOR, REMOVING AND INSTALLING .
-- Remove the bolts -1- on the rear of the door trim.
-- Drill the attachment points -arrows- on the armrest with a drill to 6.5 mm diameter from the door trim far enough that the armrest loosens from the door trim.
CAUTION:
The Door Trim Panel Must Not Be Damaged By Drilling.
-- Carefully loosen the attachment points one after another and remove the armrest -2- from the door trim.
-- Unclip the pull handle -1- with the switch mount from the arm rest -2- using the :T10383/1 -arrows- and remove.