Crash Bolster, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Remove the knee airbag with igniter. Refer to KNEE AIRBAG WITH IGNITER, REMOVING AND INSTALLING .
-- Remove The Driver Side Footwell Vent. Refer to OVERVIEW - AIR ROUTING AND AIR DISTRIBUTION IN PASSENGER COMPARTMENT .
-- Remove the Data Bus on Board Diagnostic Interface -J533-. Refer to OVERVIEW - CONTROL MODULES / DATA BUS ON BOARD DIAGNOSTIC INTERFACE -J533-, REMOVING AND INSTALLING .
-- Remove the bolt -2-, disengage the crash bolster -1- and guide it out.