Wheel Bearing Unit, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Installation is the reverse of removal, with special attention to the following:

On vehicles with electronically controlled damping (Audi magnetic ride), perform the function "Adapt the Control Position" with the Vehicle Diagnostic Tester
If the control position was reprogrammed and if the vehicle has lane assist, then it will then be necessary to calibrate the driver assistance systems front camera. Refer to DRIVER ASSISTANCE SYSTEMS FRONT CAMERA, CALIBRATING .
On vehicles with level control system sensor, perform headlamp basic setting. Refer to HEADLAMP, ADJUSTING / HEADLAMPS, CALIBRATING / LEVEL CONTROL SYSTEM SENSOR .

-- An axle alignment may be required. Refer to EVALUATING NEED FOR AXLE ALIGNMENT .