Wheel Bearing Housing, Removing And Installing: Notes
WARNING: This page is about a different variant/trim than selected.
Special Tools And Workshop Equipment Required
- Puller - Ball Joint :3287A
- Torque Wrench 1332 40-200 Nm :VAG1332
- Engine and Gearbox Jack :VAS6931
- Digital Torque Wrench :VAG1756A
- Spreader Tool :3424
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.
Mandatory Replacement Parts
- Bolt - Wheel Bearing Housing to Wheel Bearing Unit
- Nut - Ball Joint to Wheel Bearing Housing