Front Lower Control Arm Bonded Rubber Bushing: Notes
WARNING: This page is about a different variant/trim than selected.
Special Tools And Workshop Equipment Required
- Wishbone Rubber Mount Assembly Tool :T10219
- Wishbone Rubber Mount Assembly Tool Pipe :T10219/1
- Wishbone Rubber Mount Assembly Tool-Drift :T10219/2
- Press Plate :VW402
- Press Piece - Rod :VW411
- Press Piece - Multiple Use :VW412
- Installation Lubricant :G 294 421 A1 . Refer to the parts information.
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.
Mandatory Replacement Parts
- Bolts - Lower Control Arm to Subframe
- Nuts - Lower Control Arm to Ball Joint
Pressing Out the Bonded Rubber Bushing:
- Control arm removed. Refer to LOWER CONTROL ARM, REMOVING AND INSTALLING .
-- Press out bonded rubber bushings as depicted in the illustration.
- :VW411
- :T10219/1 (The opening in the pipe is down and points to the control arm)
- :VW402