Right Drive Axle With CV Joint, Connected To Inner Splines: Removing

WARNING: This page is about a different variant/trim than selected.

-- Loosen the wheel side drive shaft threaded connection -arrow-. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .

Courtesy of AUDI OF AMERICA, LLC

-- Remove the wheel. Refer to WHEELS AND TIRES .

-- Remove the noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING / OVERVIEW - NOISE INSULATION .

-- If installed disconnect the Vehicle Inclination Sensor -G384- coupling rod from the control arm, to do this remove the nuts -4-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -arrows- from the ball joint.

Courtesy of AUDI OF AMERICA, LLC

-- Disengage the control arm from the ball joint.

-- Pivot the suspension strut outward, while doing so push the drive axle out of the wheel bearing unit.

-- Slide outer joint out of wheel hub by hand.

-- Secure the drive axle to keep it from falling down.

NOTE:

In order to remove the drive axle from the transmission using the :T10382 , the suspension strut and all its components must be pulled to the back. Be careful not to damage any parts, for example, brake hose, ABS line.

-- Install the :T10382 .

Courtesy of AUDI OF AMERICA, LLC

For the CV joint -1-, the opening -arrow- in the :T10382/1 must face the :T10382/2 .

-- Attach the :T10382 to the :VW771 .

NOTE:

In order to remove the drive axle from the transmission using the :T10382 , the suspension strut and all its components must be pulled to the back.

-- Pull the suspension strut and its components using the :T10038 as far as possible to the back, for example on the workshop hoist arm, until the :T10382 can be installed parallel to the drive axle -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Install the :T10382 and remove the drive axle with a few hits on the :VW771 .

Courtesy of AUDI OF AMERICA, LLC

-- Remove the drive axle from the vehicle.