Left Drive Axle With CV Joint, Connected To Inner Splines: Notes

WARNING: This page is about a different variant/trim than selected.

Special Tools And Workshop Equipment Required

Slide Hammer Set :VW771
Puller - Driveshaft :T10382
Puller - Driveshaft - Removing Plate :T10382/1
Puller - Driveshaft - Spindles :T10382/2
Puller - Driveshaft - Traverse :T10382/3
Torque Wrench 1332 40-200 Nm :VAG1332

CAUTION:

This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.

Mandatory Replacement Parts

Nut - Ball Joint to Wheel Bearing Housing
Bolt - Drive Axle to Wheel Bearing Unit
Seal - on stub shaft on transmission
Locking Ring - on stub shaft on transmission