Triple Roller Star, Conical Drive Shaft, Installing
WARNING: This page is about a different variant/trim than selected.
The chamfer on triple roller star faces toward shaft, this is used as an assembly aid.
-- Install the triple roller star all the way onto the shaft.
-- Make sure the pressure does not increase above 3.0 T.
-- If necessary coat drive axle splines and triple roller star with Lubricating Paste:G 052 142 A2 .
-- Insert securing ring, be sure to fit properly.
-- Press half of the joint grease from the repair set into the triple roller joint.
-- Slide joint piece over rollers and secure.
-- Press the remaining half of the drive axle grease from the repair kit into the rear side of the triple roller joint.
-- Install CV boot.