Drive Axle With Triple Roller Joint AAR2600I/AAR3300I, Servicing, Mounted On Transmission Stub Shaft: Notes

WARNING: This page is about a different variant/trim than selected.

Special Tools And Workshop Equipment Required

Press Plate :VW401
Press Plate :VW402
Press Piece - Rod :VW408A
Press Piece - Rod :VW411
Press Piece - 37mm :VW416B
Press Piece - Multiple Use :VW447H
Hose Clip Pliers :VAG1275A
Torque Wrench 1331 5-50 Nm :VAG1331
Torque Wrench 1332 40-200 Nm :VAG1332
Clamping Pliers :VAG1682A
Tripod Joint Tool :T10065
Slide Hammer Set :VW771
Puller - Driveshaft :T10382
Puller - Driveshaft :T10382/1
Puller - Driveshaft - Spindles :T10382/2
Three-Arm Puller :VAS251205 (previously Kukko 45-2)

CAUTION:

This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.

Mandatory Replacement Parts

Locking Ring - Triple Roller Star with Rollers to Drive Axle
Clamp - CV Boot for Triple Roller Joint to Joint
Clamp - CV Boot for Triple Roller Joint to Drive Axle
Clamp - CV Boot to Outer CV Joint
Locking Ring - Inner CV Joint to Drive Axle
Bolt - Outer CV Joint to Drive Axle