Triple Roller Star, Conical Drive Shaft, Installing:

• The chamfer on triple roller star faces toward shaft, this is used as an assembly aid.

-- Before installing CV joint or triple roller star, splines -arrow A- must be lightly coated with grease used in joint.

Courtesy of AUDI OF AMERICA, LLC

-- Install the triple roller star all the way onto the shaft.

Courtesy of AUDI OF AMERICA, LLC

-- Make sure that pressure does not increase above 3.0 T.

-- If necessary coat drive axle splines and triple roller star with Polycarbamide grease :G 052 142 A2  .

-- Insert securing ring, be sure to fit properly.

-- Slide joint piece over rollers and secure.

-- Press 70 g drive shaft grease from repair kit into triple roller joint.

-- Press 70 g drive shaft grease from repair kit into protective joint boot.

-- Install CV boot.

-- Install clamp.