Drive Axle With Triple Roller Joint AAR 2600I, Servicing, Bolted: Notes
WARNING: This page is about a different variant/trim than selected.
Special Tools And Workshop Equipment Required
- Press Plate :VW401
- Press Plate :VW402
- Press Piece - Rod :VW408A
- Press Piece - Rod :VW411
- Press Piece - 37mm :VW416B
- Press Piece - Multiple Use :VW447H
- Tripod Joint Tool :T10065
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.
Mandatory Replacement Parts
- Bolts - Bolted Joint to Transmission
- Clamp - CV Boot for Triple Roller Joint to Profile Shaft
- Clamp - CV Boot for Triple Roller Joint to Bolted Joint
- Locking Ring - Triple Roller Star with Rollers to Profile Shaft
- Clamp - CV Boot to Outer CV Joint
- Clamp - CV Boot to Profile Shaft
- Locking Ring - Outer CV Joint to Profile Shaft
- Bolt - Outer CV Joint to Profile Shaft
-- Remove The CV Joint From The Drive Axle By Hitting It With A Light Alloy Hammer.
1 - Plate Spring
2 - Spacer ring (plastic)