108 Mm Inner CV Joint, Servicing: Notes
WARNING: This page is about a different variant/trim than selected.
Special Tools And Workshop Equipment Required
- Circlip Pliers :VW161A
- Press Plate :VW401
- Press Plate :VW402
- Press Piece - Rod :VW408A
- CV Joint Press Sleeve :VW522
- Press Block :40-204A
- Clamping Pliers :VAG1682A
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.
Mandatory Replacement Parts
- Bolt - Locking Plate to Cover
- Clamp - Protective Boot for Inner CV Joint to Cover
- Clamp - Protective Boot for Inner CV Joint to Profile Shaft
- Clamp - CV Boot for Outer CV Joint to Profile Shaft
- Clamp - Outer CV Joint to CV Boot for Outer CV Joint
- Bolt - Outer CV Joint to Profile Shaft
-- Remove the CV joint from the drive axle by hitting it with a light alloy hammer.
1 - Plate Spring
2 - Spacer Ring (plastic)