100 Mm (3.93 In.) Inner CV Joint, Servicing: Notes
WARNING: This page is about a different variant/trim than selected.
Special Tools And Workshop Equipment Required
- Press Plate :VW401
- Press Plate :VW402
- Press Piece - Rod :VW408A
- Press Piece - Rod :VW411
- Press Piece - 37mm :VW416B
- Press Piece - Multiple Use :VW447H
- Circlip Pliers :VW161A
- Torque Wrench 1331 5-50 Nm :VAG1331
- Torque Wrench 1332 40-200 Nm :VAG1332
- Clamping Pliers :VAG1682A
- Tripod Joint Tool :T10065
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.
Mandatory Replacement Parts
- Locking Ring - Inner CV Joint to Profile Shaft
- Bolt - Locking Plate to Protective Boot for Inner CV Joint
- Clamp - Protective Boot for Inner CV Joint to Profile Shaft
- Locking Ring - CV Boot for Outer CV Joint to Profile Shaft
- Clamp - CV Boot for Outer CV Joint to Profile Shaft
- Bolt - Outer CV Joint to Profile Shaft
-- Remove The CV Joint From The Drive Axle By Hitting It With A Light Alloy Hammer.
Installed Location Of Spring Washer And Thrust Washer On Outer Joint
1 - Plate Spring
2 - Spacer Ring (plastic)