Wheel Bearing Unit, Removing And Installing, Multi-Link Suspension Vehicles With Front Wheel Drive: Removing
WARNING: This page is about a different variant/trim than selected.
-- Remove the brake rotor. Refer to REAR BRAKE ROTOR, REMOVING AND INSTALLING .
-- Loosen the dust cap -3- from seat by tapping lightly on claw of the :VW637/2 -2- using the hammer -1-.
-- Press the dust cap off using the :VW637/2 -1-.
-- Remove the bolt -1- with the :T10162A .
CAUTION:
Never use an impact wrench when loosening the bolt -1- using the :T10162A .
-- Remove the wheel bearing unit -2- from the axle stub.
CAUTION:
- When setting down/storing avoid contaminating with dirt and damaging the seal.
The wheel bearing -1- must always face up.
-- Always set the wheel bearing unit down on the wheel hub -2-.