Wheel Bearing Unit, Removing And Installing, Multi-Link Suspension Vehicles With Front Wheel Drive: Notes
WARNING: This page is about a different variant/trim than selected.
Special Tools And Workshop Equipment Required
- Puller - Grease Cap :VW637/2
- Camshaft Installer Kit - Sleeve :3241/4 from the Seal Installer - Camshaft Installer Kit :3241
- Torque Wrench 1332 40-200 Nm :VAG1332
- Torque Wrench 1410 :VAG1410
- Socket - XZN 18mm :T10162A
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.
Mandatory Replacement Parts
- Bolt - Wheel Bearing Unit to Wheel Bearing Housing
- Bolt - Wheel Bearing Unit to Stub Axle
- Dust Cap
WARNING:
There is a risk of breaking the tool number :T10162 without the "A" index.
- :T10162A must be used exclusively.