Overview - Trailing Arm: Notes

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of Trailing Arm

Courtesy of AUDI OF AMERICA, LLC

Cover
Bracket
Bolt
- 50 Nm + 45°
- Always replace if removed
Bolt
- 90 Nm + 90°
- Always replace if removed
Bolt
- 70 Nm + 90°
- Always replace if removed
Bolt
- 70 Nm + 90°
- Always replace if removed
Bolt
- Tightening specification. Refer to OVERVIEW - REAR AXLE SPEED SENSOR / RIGHT/LEFT REAR ABS WHEEL SPEED SENSOR -G44- / -G46-, REMOVING AND INSTALLING .
Right Rear ABS Wheel Speed Sensor -G44- /Left Rear ABS Wheel Speed Sensor -G46-
- Removing and installing. Refer to OVERVIEW - REAR AXLE SPEED SENSOR / RIGHT/LEFT REAR ABS WHEEL SPEED SENSOR -G44- / -G46-, REMOVING AND INSTALLING .
Wheel Bearing Housing
- For FWD vehicles
Wheel Bearing Housing
- For AWD vehicles
Trailing Arm
- Removing and installing. Refer to TRAILING ARM WITH MOUNTING BRACKET, REMOVING AND INSTALLING .
Bonded Rubber Bushing
- Note installed position. Refer to OVERVIEW - TRAILING ARM
- Replacing. Refer to TRAILING ARM, SERVICING .