Overview - Stabilizer Bar
WARNING: This page is about a different variant/trim than selected.
- Stabilizer Bar
- With rubber bushings
- Removing and installing. Refer to STABILIZER BAR, REMOVING AND INSTALLING, MULTI-LINK SUSPENSION VEHICLES WITH FRONT WHEEL DRIVE .
- Coupling Rod
- Removing and installing. Refer to COUPLING ROD, REMOVING AND INSTALLING .
- Lower Transverse Link
- Nut
- 20 Nm + 180°
- Always replace if removed
- Bolt
- Always replace if removed
- Bolt
- 20 Nm + 90°
- Always replace if removed
- Install evenly
- Nut
- 55 Nm
- Counterhold at connecting link socket head when tightening
- Subframe