SUBFRAME, Installing With Attachments

WARNING: This page is about a different variant/trim than selected.

Install In Reverse Order Of Removal. Note The Following:

-- Remove the :T10096 . Refer to SUBFRAME, SECURING .

On vehicles with electronically controlled damping (Audi magnetic ride), perform the function "Adapt the control position" with the Vehicle Diagnostic Tester.
If the control position was reprogrammed and if the vehicle has lane assist, then it will then be necessary to calibrate the driver assistance systems front camera. Refer to DRIVER ASSISTANCE SYSTEMS FRONT CAMERA, CALIBRATING .
For vehicles with a level control system sensor, perform a headlamp basic setting. Refer to HEADLAMP, ADJUSTING / HEADLAMPS, CALIBRATING .
Vehicles with adaptive cruise control, calibrate the adaptive cruise control. Refer to ADAPTIVE CRUISE CONTROL (ACC), ADJUSTING .

-- Overview table for when an axle alignment is needed. Refer to EVALUATING NEED FOR AXLE ALIGNMENT .