LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A3 Premium, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 40 (Rear Suspension -- (A3 Sedan)) >> 42 Rear Suspension >> Drive Axle >> Outer CV Joint, Checking >> Installing

Outer CV Joint, Checking: Installing

WARNING: This page is about a different variant/trim than selected.

Installation is reverse of removal, Noting The Following: 

-- Press quantity of grease specified in table. Refer to DRIVE AXLE WITH 90 MM DIAMETER OUTER CV JOINT  into joint body.

-- Insert cage with hub into joint body.

NOTE:

Cage must be installed laterally correct.

-- Press in opposing balls in sequence, during this, previous position of ball hub to ball cage and to joint body must be established again.

-- Install new circlip in shaft.

-- Distribute remaining grease in the joint boot.

scientia non olet · About LEMON Manuals