LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A3 Premium, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 40 (Rear Suspension -- (A3 Sedan)) >> 42 Rear Suspension >> Drive Axle >> Drive Axle, Disassembling And Assembling >> Drive Axle With 90 Mm Outer CV Joint, Servicing >> Outer CV Joint With Bolt, Installing

Outer CV Joint With Bolt, Installing

WARNING: This page is about a different variant/trim than selected.
GWWA42-10049Courtesy of AUDI OF AMERICA, LLC

-- Before installing joint piece, splines -arrow A- must be lightly coated with grease used in joint.

-- Install old drive shaft bolt in joint as shown in the illustration.

GWWA42-0301Courtesy of AUDI OF AMERICA, LLC

-- Drive joint onto shaft with plastic hammer until circlip engages.

Fig 1: Locating Circlip
GWWA40-0158Courtesy of AUDI OF AMERICA, LLC