Dryer Cartridge, Removing And Installing, DENSO Condenser: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal and Note The Following:

NOTE:

Replace the plug, O-ring and dryer cartridge after every opening of the receiver/dryer.

-- Using the opening, inspect the receiver/dryer on the condenser for dirt and damage on the threaded- and sealing surfaces.

NOTE:

Keep the dryer cartridge sealed in its air-tight package as long as possible. Open the package just before installing the dryer cartridge into the condenser. The dryer cartridge absorbs moisture from the surrounding air in a very short time and becomes unusable.

Coat the O-ring for the plug with refrigerant oil before installing. Refer to REFRIGERANT CIRCUIT SEALS .

-- Insert the filter element -E- into the condenser receiver/dryer on the proper side.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the dryer cartridge -D- from the package and insert it into the dryer carrier -C-.

-- Insert the dryer carrier together with the dryer cartridge into the condenser receiver/dryer.

-- Position and install the plug -A-.

-- Evacuate and charge the refrigerant circuit. Refer to REFRIGERANT CIRCUIT, DISCHARGING WITH A/C SERVICE STATION (R134a) / REFRIGERANT CIRCUIT, EVACUATING WITH A/C SERVICE STATION (R134a) / REFRIGERANT CIRCUIT, CHARGING WITH A/C SERVICE STATION (R134a) (Refrigerant R134a Servicing, Refrigerant Circuit, Working with A/C Service Station) or REFRIGERANT CIRCUIT, DISCHARGING (R1234yf) / REFRIGERANT CIRCUIT, EVACUATING (R1234yf) / REFRIGERANT CIRCUIT, CHARGING (R1234yf) .

-- Operate the A/C system after charging the refrigerant circuit. Refer to A/C SYSTEM, STARTING OPERATION AFTER FILLING REFRIGERANT CIRCUIT .

-- Check the DTC memory and erase any displayed entries using the :Vehicle Diagnostic Tester in the "Guided Fault Finding" function.