Overview - Front Brakes, Brakes 1LC/1LJ/1ZA/1ZD/1ZE/1ZP: Notes
WARNING: This page is about a different variant/trim than selected.
- Brake Caliper
- Allocation. Refer to the Electronic Parts Information (ETKA).
- Refer to BRAKE CALIPER, REMOVING AND INSTALLING
- Refer to BRAKE CALIPER, REPLACING, BRAKE 1LC/1LJ/1ZA/1ZD/1ZE/1ZP
- Refer to BRAKE CALIPER PISTON, REMOVING AND INSTALLING
- Refer to BRAKE CALIPER BALANCE WEIGHT
- Bleed Screw
- 10 Nm
- Before installing, thinly coat with Assembly Paste:G 052 150 A2 .
- Protective Cap
- Bolt
- 35 Nm
- Bearing Bushing
- Guide Pin
- Wheel Bearing Housing
- Bolt
- 200 Nm
- Banjo Bolt
- 35 Nm
- Permanent with gaskets
- Clean any corrosion from the sealing surface on the brake caliper
- Brake Hose
- Make sure the brake hose is routed correctly. Make sure the brake hose is not pinched, bent, twisted or rubbing against the vehicle.
- Replace if damaged
- Make sure that tabs are properly seated in the grooves on the bracket.
- Bracket
- For the brake line/hose
- Brake Line
- Brake line to brake hose tightening specification: 14 Nm
- Springs
- Replace if damaged
- Bracket
- For brake hose and wire
- Bolt
- 8 Nm
- Brake Shield
- Brake Rotor
- Allocation. Refer to the Parts Information.
- Always replace on both axles.
- Do not use excessive force to separate the brake rotor from the wheel hub. Use rust remover, if necessary, otherwise the brake rotor could be damaged.
- Allocation. Refer to the Parts Information.
- Refer to BRAKE ROTOR, REMOVING AND INSTALLING
- Bolt
- 4.5 Nm
- Bolt
- 12 Nm
- Brake Carrier
- Thinly coat the contact surfaces for the brake pads with Lithium Grease:G 052 150 A2
- Brake Pads
- Allocation. Refer to the Parts Information.
- Check the pad thickness. Refer to appropriate service information.
- Always replace on both axles.
- Refer to BRAKE PADS, REMOVING AND INSTALLING
- Pay attention to the installation position: inner right brake pad with brake pad wear sensor
- Trim with Emblem
- Equipped on some models
- Grommet
- For equipment levels with trim
NOTE:
Clean the bolts and nuts before reusing.
Always replace self-locking nuts and bolts.
Always replace damaged nuts and bolts.