Brake Caliper, Removing And Installing, Front Brakes, RS 3, 1LF, 1LH, 1LU: Removing
WARNING: This page is about a different variant/trim than selected.
The bolts -arrows- on the brake caliper for the brake carrier -1- and the tension strut -2- may not be loosened.
CAUTION:
Risk of malfunction.
- The bolts -arrows- on the brake caliper for the brake carrier -1- and the tension strut -2- may not be loosened.
-- Remove the affected front wheel. Refer to WHEELS AND TIRES .
-- Disconnect the connector -1- for the brake pad wear sensor on the right brake caliper.
NOTE:
Ignore -2-.
NOTE:
For easier removal of the brake caliper from the brake rotor, push the brake pads -3 and 4- back lightly with pliers -1-. To prevent damage to the coating on the brake caliper, place a piece of rubber -2- or similar between the pliers and brake caliper.
-- Unscrew the bolts -arrows- and carefully remove the brake caliper with the brake pads from the brake rotor.
CAUTION:
- Do not let the brake caliper hang on the brake hose. Do not support the weight with the brake hose.
- Replace the brake hose if damaged.
- Do not press the brake pedal when the brake caliper is removed.
-- Hang the brake caliper on the body using a suitable wire.