Brake Caliper, Removing And Installing, Brakes 1LC/1LJ/1ZA/1ZD/1ZE/1ZP: Removing
WARNING: This page is about a different variant/trim than selected.
-- Remove the affected front wheel. Refer to WHEELS AND TIRES .
-- Disconnect the connector -arrow- for the brake pad wear indicator contact from the right brake caliper.
NOTE:
For easier removal of the brake caliper from the brake rotor, push the brake pad -3- back slightly with suitable pliers -1- as shown.
To prevent damage to the coating on the brake caliper, place a piece of rubber -2- or similar between the pliers and brake caliper.
-- Remove the bolts -arrows- and carefully remove the brake caliper with the brake carrier and the installed brake pads from the brake rotor.
CAUTION:
There is a risk of damaging the brake hose.
- Do not let the brake caliper hang on the brake hose. Do not support the weight with the brake hose.
- Replace the brake hose if damaged.
There is a risk of damaging the brake caliper piston.
- Do not press the brake pedal when the brake caliper is removed.
-- Hang the brake caliper on the body using a suitable wire.