Overview - Brake Pedal: Notes
WARNING: This page is about a different variant/trim than selected.
NOTE:
Clean the bolts and nuts before reusing.
Always replace self-locking nuts and bolts.
Always replace damaged nuts and bolts.
WARNING:
Risk of accident!
- The path of the brake pedal must not be shortened by extra floor mats.
- Brake Pedal
- Bearing Shell
- Installed between the brake booster mount and the brake pedal
- Mount
- For the brake booster ball head
- Bearing Bushing
- Cannot be replaced
- Note the installation position
- Bushing
- Oval
- Clip
- For mounting pin
- Replace after removing.
- Bushing
- Oval
- Nuts
- Self-locking
- Replace after removing.
- Refer to MOUNTING BRACKET - TIGHTENING SPECIFICATION AND SEQUENCE
- Bushings
- Round
- Pedal Assembly/Mounting Bracket
- Mounting Pin
- Remove the mounting bracket to remove.
- Cannot be removed without being damagedCAUTION:
Do not lubricate or grease the mounting pin. The mounting pin must remain dry.
- Pedal Rubber
NOTE:
Clean the bolts and nuts before reusing.
Always replace self-locking nuts and bolts.
Always replace damaged nuts and bolts.