Brake Pedal, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
NOTE:
Clean the bolts and nuts before reusing.
Always replace self-locking nuts and bolts.
Always replace damaged nuts and bolts.
NOTE:
Replace the mounting pin and clip after removing.
CAUTION:
- Do not lubricate or grease the mounting pin. The mounting pin must remain dry.
- Both bearing bushings must be located in the brake pedal bearing so that the brake pedal is securely guided into the mounting bracket.
-- Insert the new clip -1- into the holes on the mounting bracket -arrows-.
-- Install the new mounting pin -1- while securing the clip from moving.
-- Turn the mounting pin counter-clockwise using the 14 mm hex socket wrench until the tabs -3 and 4- engage audibly.
- The arrow marking must align with the locating tab -2- on the mounting bracket as shown.
WARNING:
Risk of accident!
- Make sure the brakes are working correctly before driving the vehicle for the first time.