Dust Cap, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
- Piston is driven back.
- The parking brake motor is removed.
CAUTION:
Risk of destroying the thread
- The piston must not be removed too far.
-- Remove the piston a maximum of 20 mm -dimension a- counter-clockwise using a TORX® insert -arrow-.
-VAS40338-
-- Carefully pry out the protective cap -1- and the seal from the brake caliper with the -VAS40338- -2- using gentle lever movements, and do not damage the groove in the brake caliper for the cap while doing so.