Bleeding With Abs Hydraulic Unit -N55- Pump

WARNING: This page is about a different variant/trim than selected.

If the brake system cannot be bled correctly, proceed as follows:

NOTE:

The hydraulic pump must be activated by the interchange test.

-- Bleed the hydraulic system. Refer to HYDRAULIC SYSTEM, BLEEDING .

Also:

-- Connect the Vehicle Diagnostic Tester.

-- Switch the ignition on.

-- Select and start OBD mode.

-- Select 003- Brake Electronics .

-- Select the Basic Setting button.

-- Bleed the brakes.

-- Use login 40168.