Brake System Pressure Reservoir -VX70-, Pre-Bleeding: Procedure
WARNING: This page is about a different variant/trim than selected.
-- Attach the bleeder bottle -2- to the Brake System Pressure Reservoir -VX70- with a suitable bleed hose.
-- Open the bleeder valve -arrow A-.
-- Fill with brake fluid until it comes out of the threaded hole -arrow B- free of bubbles.
-- Close the bleed valve.
-- Seal the threaded hole with a plug from the Assembly Part Set: 5Q0 698 311 .
-- Install the Brake System Pressure Reservoir -VX70-. Refer to BRAKE SYSTEM PRESSURE RESERVOIR -VX70-, REMOVING AND INSTALLING .