Determine Position Of The Error: Procedure

WARNING: This page is about a different variant/trim than selected.

It is very difficult to find the exact location of the problem. Replace the damaged fiber-optic cable and lay a new wire parallel to the defective fiber-optic cable.

NOTE:

Via the "Guided Fault Finding" it can be determines which component of the fiber-optic cable is damaged.

A fiber-optic cable that needs repair is represented by a "yellow" color.

-- Perform in the "Off-board Diagnostic Information System Service" the "Ring break diagnosis" function in the Vehicle Diagnostic Tester.

-- Remove the affected components.

-- Disconnect the connector from the components.

-- Assemble the fiber-optic cable:

Refer to FIBER-OPTIC CABLE, PREPARING WITH THE Fiber-Optic Conductor Repair Set
Refer to FIBER-OPTIC CABLE, PREPARING WITH THE Fiber-Optic Conductor Repair Set