Right A-Pillar Connector Station, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- With the ignition switched off, disconnect the ground cable from the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING, ENGINE COMPARTMENT BATTERY .
-- Remove the A-pillar lower trim. Refer to appropriate service information. .
-- Release the retainers in direction of -arrows- and disengage the connector station -1- at the A-pillar.
-- Disconnect the connector -2-.
-- Open the clip -3- in direction of -arrow- and remove the connector terminal -2- from the bracket -1-.
NOTE:
Check the exact connector assignment in the current wiring diagram. Refer to Wiring Diagram.