Left A-Pillar Connector Station, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- With the ignition switched off, disconnect the ground cable from the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING, ENGINE COMPARTMENT BATTERY .

-- Remove the A-pillar lower trim. Refer to appropriate service informationv .

-- Release the retainers in direction of -arrows- and disengage the connector station -3- at the A-pillar.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1, 2, 4 and 5-.

-- Open the clip -3- in direction of -arrow- and remove the connector terminal -2- from the bracket -1-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Check the exact connector assignment in the current wiring diagram. Refer to Wiring Diagram.