Overview - Windshield Washer System, AUDI RS3
WARNING: This page is about a different variant/trim than selected.
- Washer Fluid Reservoir
- With Windshield Washer Fluid Level Sensor -G33- Cannot be replaced separately if faulty.
- Removing and Installing. Refer to WASHER FLUID RESERVOIR, REMOVING AND INSTALLING, AUDI RS3 .
- Wire Package
- With wiring harness and washer fluid hose for front and rear window washer system
- Grommet
- Replace if damaged.
- Filler Neck with Filler Tube
- For the washer fluid reservoir
- Removing and Installing. Refer to WASHER FLUID RESERVOIR FILLER TUBE, REMOVING AND INSTALLING, AUDI RS3 .
- Nut
- 8 Nm
- Screen
- Cap
- For the filler neck
- Right Spray Nozzle
- Vehicle equipment version with Right Washer Nozzle Heater -Z21-
- Removing and Installing. Refer to SPRAY NOZZLES, REMOVING AND INSTALLING .
- Adjusting. Refer to appropriate service information .
- Washer Fluid Hose
- For the windshield washer system
- Left Spray Nozzle
- Vehicle equipment version with Left Washer Nozzle Heater -Z20-
- Removing and Installing. Refer to SPRAY NOZZLES, REMOVING AND INSTALLING .
- Adjusting. Refer to appropriate service information.
- Grommet
- For the windshield washer fluid hose inside the hood
- Windshield And Rear Window Washer Pump -V59-
- Removing and Installing. Refer to Windshield and Rear Window Washer Pump -V59-, REMOVING AND INSTALLING, AUDI RS3 .
- Grommet
- Replace if damaged.
- Grommet
- Replace if damaged.
- Windshield Washer Fluid Level Sensor -G33-
- Removing and Installing. Refer to WINDSHIELD WASHER FLUID LEVEL SENSOR, REMOVING AND INSTALLING, AUDI RS3 .
- Nut
- 8 Nm
- Nut
- Quantity: 2
- 8 Nm