LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A3 Premium, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Wiper/Washer Systems -- (A3 Sedan)) >> 92 Wiper/Washer Systems >> Rear Window Wiper System >> Windshield Wiper Arm, Removing And Installing >> Removing

Windshield Wiper Arm, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Turn on the ignition.

-- Activate "rear wipe" and let the wiper arm run to end position.

-- Turn off the ignition.

-- Vehicle equipment version with mechanical ignition switch: Remove the key.

-- Vehicle equipment version with electronic ignition switch: Remove the key from the vehicle.

-- Carefully expand the cap in direction of -arrows- and remove.

GWWA92-0143Courtesy of AUDI OF AMERICA, LLC

-- Carefully remove the spray nozzle -2-.

GWWA92-0144Courtesy of AUDI OF AMERICA, LLC

-- Loosen the nut -1- one turn.

-- Install an M6 nut -4- on the nut.

GWWA92-10131Courtesy of AUDI OF AMERICA, LLC

-- Position the :T10369/1  on the wiper arm -1- as illustrated.

-- Position the thrust piece -2- on the wiper axle.

-- Rotate the bolt -3- clockwise until the wiper arm is removed from the axle.

-- Remove the nuts and remove the wiper arm.