Height, Adjusting Using Adjusting Buffer
WARNING: This page is about a different variant/trim than selected.
Special Tools And Workshop Equipment Required
- Gauge - Gap Adjustment:3371
- Adjustment dimensions. Refer to ADJUSTMENT DIMENSIONS .
-- Install the adjusting screw -2- and cap -1- all the way into the adjusting buffer -3- before adjusting the rear lid.
-- Remove the adjusting screw just far enough until the cap touches the stop on the rear lid when the lid is closed.
-- Push and pull on the side edges of the rear lid under the rear window to make sure there is no play and that it closes flush.
-- Repeat the adjustment if necessary.