Hinge Cable Guide, Removing And Installing
WARNING: This page is about a different variant/trim than selected.
- Cable Guide
- Removing
-- Remove the side cover from the cable guide.
-- Pull the spreader pin from the clip and remove the cable guide with the clip from the hinge.
- Installing
-- Push the cable guide with the clips in the hinge.
-- Push the spreader pin in the clip.
-- Push the wiring harness in the retaining tabs.
-- Clip the cover over the entire length of the cable guide and adjust until stop or until it engages.
- Removing
- Cover
- The entire length of it must be attached with the cable guide. Refer to HINGES, REMOVING AND INSTALLING, SEDAN .
- Rear Lid
- Hinge