LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A3 Premium, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 23 (Hood, Lids -- (A3 Sedan)) >> 55 Hood, Lids >> Rear Lid >> Gas-Filled Strut, Removing And Installing. >> Gas-Filled Strut, Disengaging >> Procedure

Gas-Filled Strut, Disengaging: Procedure

WARNING: This page is about a different variant/trim than selected.

-- Support the lid or secure it against falling.

-- Using a small screwdriver, lift the locking spring -1- slightly and remove the gas-filled strut -2- from the upper ball pin.

GWWA55-10891Courtesy of AUDI OF AMERICA, LLC

-- Repeat the procedure on the lower ball pin.

scientia non olet · About LEMON Manuals