Routing The Release Cable Inside The Engine Compartment
WARNING: This page is about a different variant/trim than selected.
- Grommet
- Fender Flange
- Release Cable
-- Starting from the interior, route the release cable -3- forward in the engine compartment and along the fender mounting flange as illustrated.
-- Press the release cable completely in the clips.
-- Push the coupling into the lock carrier. Refer to RELEASE CABLE, REMOVING AND INSTALLING .
- Latch
- Removing and installing. Refer to LATCH, REMOVING AND INSTALLING .
- Release Cable Coupling
- Knurl
- To adjust so that the hood catches unlock evenly.
- Clip