Latch, Removing And Installing: Notes
WARNING: This page is about a different variant/trim than selected.
- Latch
-- Left: remove the washer fluid reservoir filler neck. Refer to WINDSHIELD WASHER SYSTEM .
-- Remove the bolts and pull the rear lid latch from the lock carrier.
- Engage the release cable. Refer to RELEASE CABLE, REMOVING AND INSTALLING .NOTE:
To adjust the hood height, move the lid lock up or down as required.
- Engage the release cable. Refer to RELEASE CABLE, REMOVING AND INSTALLING .
- Lock Carrier
- Bolt
- 11 Nm
- Connector
- When installing the rear lid latch, press in and lock the connector in the lock carrier.